Svenska ElektronikForumet

Kod: Markera allt

/*
  Blink
  Turns on an LED on for one second, then off for one second, repeatedly.
 
  This example code is in the public domain.
 */
 
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;

// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);    
}

// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);               // wait for a second
  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);               // wait for a second
}

Kod: Markera allt

/*
  Blink
  Turns on an LED on for one second, then off for one second, repeatedly.
 
  This example code is in the public domain.
 */
 
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;

// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);    
}

// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);               // wait for a second
  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);               // wait for a second
}

Kod: Markera allt

Done burning bootloader

Kod: Markera allt

Compiling 'Sketch1' for 'Arduino Uno'
Binary sketch size: 486 bytes (used 2% of a 32 256 byte maximum) (0,67 secs)
Uploading to I/O board using 'AVRISP mkII'
Done uploading

Kod: Markera allt

Compiling 'Sketch1' for 'Arduino Uno'
Binary sketch size: 486 bytes (used 2% of a 32 256 byte maximum) (0,66 secs)
Uploading to I/O board using 'COM3'
Done uploading

Kod: Markera allt

/*
  Blink
  Turns on an LED on for one second, then off for one second, repeatedly.
 
  This example code is in the public domain.
 */
 
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;

// the setup routine runs once when you press reset:
void setup() {                
  // initialize the digital pin as an output.
  pinMode(led, OUTPUT);    
}

// the loop routine runs over and over again forever:
void loop() {
  digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(3000);               // wait for a second
  digitalWrite(led, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);               // wait for a second
}

Kod: Markera allt

Compiling 'Regulator_kod' for 'Arduino Uno'
Binary sketch size: 1 084 bytes (used 3% of a 32 256 byte maximum) (0,41 secs)
Uploading to I/O board using 'AVRISP mkII'
Done uploading

Kod: Markera allt

Compiling 'Regulator_kod' for 'ATmega328 on a breadboard (16 MHz internal clock)'
Binary sketch size: 1 084 bytes (used 3% of a 32 256 byte maximum) (0,50 secs)
Uploading to I/O board using 'AVRISP mkII'
Done uploading